Hatteland-display HT B18 (Fanless) Manual de usuario descargar pdf (Pagina 18)

IND100210-6

General Installation Recommendations

Installation

Internal SSD (Hard Drive HDD) removal / replacement HT B1x

Note: Areas of interest are marked in this section with symbols in RED color. Please power off and disconnect ALL

cables from the computer unit before proceeding! HT B17 used as illustration in this procedure, but it is valid for both

HT B17 and HT B18 computers.

▼ 1: Unscrew the bottom cover plate (10 pcs of

M3x6mm Torx countersunk screws and lift the cover

up.

▼ 2: Unscrew 2 pcs x M3x4mm Phillips countersunk

screws and 2 pcs x M3 Fastener Nut as indicated. Then

lift the entire SSD Device bracket up.

▼ 3: Unscrew 4 pcs x M3x4mm Phillips countersunk

screws as indicated and replace or remove the SSD

drive as needed.

▼ 4: Connect your Serial ATA cable ~20cm (not included)

to the SSD. Power Cable is already available from the

internal power module.

To SSD To HT B1x Motherboard

- Repeat the procedure backwards to nalize operation -

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 57 58

Sin comentarios

Hatteland-display HT B18 (Fanless) Manual de usuario Pagina 18